13 posts • Page 1 of 1
Does anyone know if when solving for an initial volume using the formula M(inital)V(inital) = M(final)V(final), would I have to convert the final volume originally given in mL to liters? In other words, when is it necessary to convert mL to liters? Thanks!
Hi! I don't think it really matters, but I tend to convert to liters if the value exceeds the thousands place. So I would convert 3,000 ml to 3 L just to keep it shorter. I think a TA said that it doesn't matter for the test!
Hello! I'm don't think it is completely necessary to convert your answers to mL from Liters, but I usually do since there are sometimes other steps to the problem where you are subtracting a volume from a greater volume and in this case they would both need to have matching units.
I don't think it matters, I just prefer to keep it in liters because molarity of a solution is moles/liters. But for the M1V1 equation, since you are essentially finding a value using a ratio, whether you choose mL or L does not matter as long as you are consistent and that you specify.
It does not matter if you use mL or L, but you have to stay consistent throughout the whole problem. I usually just change to liters.
I prefer to convert mL to L because Molarity is moles/L, as mentioned above. It is only necessary to convert from mL to L if the problem specifically asks for liters or vice versa. Mr. Lavelle usually specifies in the question, so be sure to always to aware of units in your final answer. Hope this helps.
I would suggest always converting to Liters because molarity is moles/liters and the units always have to be consistent!
Unless the problem specifically states that you need to keep the answer in L or convert it to mL, I wouldn't worry about it. However, since Molarity = moles/liters, it's a good idea to convert in the beginning itself.
Like everyone else said, it isn't necessarily required. However, if you ever want to use that volume to find molarity or moles, you would need to convert it into L, so I would say that it is usually best to do so at the beginning of a problem regardless.
It doesn't matter but make sure that if you are using mL you are using mL for both Vinitial and Vfinal. The reason it doesn't matter whether it is mL or L it is the same ratio.
You can use either L or mL as long as you are consistent with the units throughout your calculations.
The standard one for this equation is Liters, but if asked otherwise, you should probably use liters for your volume.
L or mL is fine, just make sure to have matching units all throughout. It wouldn't hurt to change it at the beginning, since molarity is moles/L.
Who is online
Users browsing this forum: No registered users and 1 guest