Percent Yield  [ENDORSED]

Moderators: Chem_Mod, Chem_Admin

veneziaramirez 3I
Posts: 57
Joined: Fri Sep 29, 2017 7:07 am

Percent Yield

Postby veneziaramirez 3I » Thu Oct 05, 2017 12:26 am

Why is having a high percentage yield good? Around what percentage is considered good?

Wenxin Fan 1J
Posts: 53
Joined: Thu Jul 13, 2017 3:00 am

Re: Percent Yield  [ENDORSED]

Postby Wenxin Fan 1J » Thu Oct 05, 2017 1:37 am

A high percent yield means that there were fewer outside errors in the application of a chemical reaction. You want the actual yield to be as close to the theoretical yield as possible to allow for more accurate predictions and calculations. High yield may indicate that there are fewer impurities in the compounds involved, fewer environmental factors that cause discrepancies, and less product stuck to the side of a test tube (when actually conducting an experiment). There isn't a set yield that is considered "good." I hope that helped.

-Wenxin Fan 1H

Sarah_Stay_1D
Posts: 57
Joined: Sat Jul 22, 2017 3:00 am
Been upvoted: 1 time

Re: Percent Yield

Postby Sarah_Stay_1D » Thu Oct 05, 2017 8:54 am

In a lab setting, chemist typically try to achieve a a yield of 90% of higher. This is primarily because in an actual experiment, there is often more than one reaction, so if the yield of the first reaction is low, the yield will get lower with each consecutive reaction.

204918982
Posts: 50
Joined: Fri Sep 29, 2017 7:04 am

Re: Percent Yield

Postby 204918982 » Thu Oct 05, 2017 8:52 pm

A high percent yield is better because it suggests that there were fewer impurities that occurred during the experiment and can help with the accuracy of calculations.

Chris Pleman 3E
Posts: 51
Joined: Thu Jul 27, 2017 3:01 am
Been upvoted: 2 times

Re: Percent Yield

Postby Chris Pleman 3E » Thu Oct 05, 2017 9:38 pm

Also, another reason a high yield is important is if you're preparing a solution or a chemical that is an intermediate step to a larger experiment, the lower the yield the worse off the entire experiment becomes. If you think about it mathematically, it's similar to the function p= (C)^x where C is your percent yield, and x is the number of dependent experiments run one after the other. Even if you have a 90% yield at each step, your overall accuracy drops drastically: after five consecutive experiments your yield will become around 59%.

Chloe Blume 1F
Posts: 15
Joined: Fri Sep 29, 2017 7:04 am

Re: Percent Yield

Postby Chloe Blume 1F » Sun Oct 08, 2017 11:07 am

Having a high percentage yield is good because that means the product is being created to its full capacity. This is important when performing experiments because chemists want to make sure they are being as accurate as possible and if not all their product is forming then this can cause for wrong measurements.


Return to “Limiting Reactant Calculations”

Who is online

Users browsing this forum: No registered users and 2 guests