## higher entropy cis or trans

Boltzmann Equation for Entropy: $S = k_{B} \ln W$

Franca Park 3J
Posts: 64
Joined: Fri Sep 25, 2015 3:00 am

### higher entropy cis or trans

Considering positional disorder, would you expect a crystal of octahedral cis-MX2Y4 to have the same, higher, or lower residual entropy than the corresponding trans isomer? Explain your conclusion

The solutions manual says that for the cis compound there will be 12 different orientations while for the trans compound there will be 3 different orientations. How did they get 12 and 3?

Chem_Mod
Posts: 18400
Joined: Thu Aug 04, 2011 1:53 pm
Has upvoted: 435 times

### Re: higher entropy cis or trans

The geometry it is talking about is the octahedral arrangement, where there are 6 directions for ligands: up, down, left, right, front, and back

With a little visualization it should be clear that there are only 3 pairs of positions that are 180 degrees apart but there are 12 pairs of positions that are 90 degrees apart

Marsenne Cabral 1A
Posts: 59
Joined: Fri Sep 28, 2018 12:19 am

### Re: higher entropy cis or trans

I am still confused though, is the trans isomer only looking at the molecules 180 degrees apart?

Michael Torres 4I
Posts: 92
Joined: Thu May 10, 2018 3:00 am
Been upvoted: 1 time

### Re: higher entropy cis or trans

The molecule featured possesses an octahedral geometry. Consider X1, X2, X3, and X4 to span horizontally across the molecule, with odd numbers being positioned opposite from each other and even numbers being positioned opposite from each other. Now, consider Y1 and Y2 to be the points on the opposite top and bottom ends of the molecule. This arrangement should reflect that present in the book.

Now, in a trans molecule the occupied positions must lie opposite from each other, so (Y1, Y2), (X1, X3), and (X2, X4) fit this requirement. If occupied, only these three positions would lie opposite from each other. Because they are opposite from each other, these positions also lie 180 degrees apart. (It is required that there be 180 degrees of separation in a trans molecule in order to maintain non-polarity and proper symmetry.)

In a cis molecule, positions must not lie opposite from each other. Therefore, (X1, X2), (X2, X3), (X3, X4), (X4, X1), (Y1, X1), (Y1, X2), (Y1, X3), (Y1, X4), (Y2, X1), (Y2, X2), (Y2, X3), and (Y2, X4) fit this requirement. If occupied, these twelve positions satisfy a cis arrangement in that they are not opposite from each other. In fact, they all lie 90 degrees apart from each other.

I realize this is abstract, but please try to visualize it and I think it will make more sense.

Annie Chantasirivisal_4G
Posts: 114
Joined: Wed Sep 18, 2019 12:21 am

### Re: higher entropy cis or trans

I drew them out so that it's easier to visualize the 12 cis and the 3 trans in case anyone is also struggling like me; the above comment definitely helped me understand this problem a lot better, thank you so much!

I circled the X so that it's easier to see how each molecule differs in position! :>

KaleenaJezycki_1I
Posts: 127
Joined: Sat Aug 17, 2019 12:18 am
Been upvoted: 2 times

### Re: higher entropy cis or trans

Annie Chantasirivisal_4G wrote:IMG_0853 2.jpg
I drew them out so that it's easier to visualize the 12 cis and the 3 trans in case anyone is also struggling like me; the above comment definitely helped me understand this problem a lot better, thank you so much!

I circled the X so that it's easier to see how each molecule differs in position! :>

Is this something that was covered in class or we should know for the midterm?

Annie Chantasirivisal_4G
Posts: 114
Joined: Wed Sep 18, 2019 12:21 am

### Re: higher entropy cis or trans

KaleenaJezycki_1I wrote:
Annie Chantasirivisal_4G wrote:IMG_0853 2.jpg
I drew them out so that it's easier to visualize the 12 cis and the 3 trans in case anyone is also struggling like me; the above comment definitely helped me understand this problem a lot better, thank you so much!

I circled the X so that it's easier to see how each molecule differs in position! :>

Is this something that was covered in class or we should know for the midterm?

Sorry for the late reply, but as you can tell it was not on the midterm. This is just a review of 14A with cis and trans placement, but I think we'll get into more detail of it during 14C and D with O-chem :>

Edit:
Sorry, for clarification: drawing them out isn't necessary but I did it so that I could obtain the maximum possible number of positions the molecule could be in (14A stuff). But technically, that position part is what we need to know for 14B since it's part of entropy (the W in S=KblnW) and since we didn't get a chance to use that formula in the midterm I suspect it might be in the final.

Mai V 4L
Posts: 111
Joined: Fri Sep 28, 2018 12:23 am

### Re: higher entropy cis or trans

Annie Chantasirivisal_4G wrote:
KaleenaJezycki_1I wrote:
Annie Chantasirivisal_4G wrote:IMG_0853 2.jpg
I drew them out so that it's easier to visualize the 12 cis and the 3 trans in case anyone is also struggling like me; the above comment definitely helped me understand this problem a lot better, thank you so much!

I circled the X so that it's easier to see how each molecule differs in position! :>

Is this something that was covered in class or we should know for the midterm?

Sorry for the late reply, but as you can tell it was not on the midterm. This is just a review of 14A with cis and trans placement, but I think we'll get into more detail of it during 14C and D with O-chem :>

Edit:
Sorry, for clarification: drawing them out isn't necessary but I did it so that I could obtain the maximum possible number of positions the molecule could be in (14A stuff). But technically, that position part is what we need to know for 14B since it's part of entropy (the W in S=KblnW) and since we didn't get a chance to use that formula in the midterm I suspect it might be in the final.

Since it wasn't on the midtem do you think it will be on the final?

Annie Chantasirivisal_4G
Posts: 114
Joined: Wed Sep 18, 2019 12:21 am

### Re: higher entropy cis or trans

Mai V 4L wrote:
Annie Chantasirivisal_4G wrote:
KaleenaJezycki_1I wrote:
Is this something that was covered in class or we should know for the midterm?

Sorry for the late reply, but as you can tell it was not on the midterm. This is just a review of 14A with cis and trans placement, but I think we'll get into more detail of it during 14C and D with O-chem :>

Edit:
Sorry, for clarification: drawing them out isn't necessary but I did it so that I could obtain the maximum possible number of positions the molecule could be in (14A stuff). But technically, that position part is what we need to know for 14B since it's part of entropy (the W in S=KblnW) and since we didn't get a chance to use that formula in the midterm I suspect it might be in the final.

Since it wasn't on the midtem do you think it will be on the final?

Possibly! We didn't really calculate entropy using S=KblnW so Dr. Lavelle might have it appear in our final exam. Anything is fair game if he's mentioned it during lecture.

Return to “Third Law of Thermodynamics (For a Unique Ground State (W=1): S -> 0 as T -> 0) and Calculations Using Boltzmann Equation for Entropy”

### Who is online

Users browsing this forum: No registered users and 2 guests