Using variables in ICE tables

Moderators: Chem_Mod, Chem_Admin

Schuyler_Howell_4D
Posts: 66
Joined: Fri Sep 28, 2018 12:28 am
Been upvoted: 1 time

Using variables in ICE tables

Postby Schuyler_Howell_4D » Sun Jan 13, 2019 11:21 am

Can someone explain when you should use variables such as X in an ICE table versus finding the change based on stoichiometric coefficients before being plugged into the table?

In one of the Audio-Visual Learning Modules (I think equilibrium part 2) Dr.Lavelle went ahead and used mole ratios to find the change of each product and each reactant before using the table. I understand that using the variables in the table is essentially using the mole ratios but just without actual values at first but, still, when should we use each approach?

Mahir_Hasan2C
Posts: 60
Joined: Fri Sep 28, 2018 12:25 am

Re: Using variables in ICE tables

Postby Mahir_Hasan2C » Sun Jan 13, 2019 11:26 am

It's much easier cause x can be anything thus it is used to define the change in molarity. It also makes things easier in the algebraic sense. Then we put whatever coefficient in front of x to display the conservation of matter. For example, if 1 reactant produced 2 product we would have -x and +2x because 1mole of reactant would always produce 2 moles of product.

Porus_Karwa_2E
Posts: 72
Joined: Fri Sep 28, 2018 12:24 am

Re: Using variables in ICE tables

Postby Porus_Karwa_2E » Sun Jan 13, 2019 12:05 pm

To add onto the above comment the X variable is much easier to use as after you are done assigning variables we would just need to use the quadratic equation.


Return to “Equilibrium Constants & Calculating Concentrations”

Who is online

Users browsing this forum: No registered users and 2 guests