symbol of Heat

Moderators: Chem_Mod, Chem_Admin

Baoying Li 1B
Posts: 113
Joined: Sat Aug 17, 2019 12:18 am

symbol of Heat

Postby Baoying Li 1B » Thu Jan 23, 2020 10:48 pm

What do these symbols represent specifically? H, delta H, Delta H naught, qp, q.

Cole Woulbroun 1J
Posts: 56
Joined: Thu Jul 25, 2019 12:16 am

Re: symbol of Heat

Postby Cole Woulbroun 1J » Fri Jan 24, 2020 12:23 am

H can be viewed as a system's enthalpy, or its total internal energy. While this energy often takes the form of heat, this is not always the case. It can apply to other forms of energy as well. Since H represents energy, delta H represents the change in this energy over the course of a chemical reaction. Delta H naught represents this change at standard conditions, as based on the conditions the reaction undergoes, the delta H value can change. Q represents solely heat energy, as it is directly related to the heat capacity of a substance, or the amount of heat energy that must be put into a substance to increase its temperature. As for Qp, I am not sure, but it is likely a derivative of Q, which represents heat energy.

Connie Chen 1E
Posts: 51
Joined: Mon Jun 17, 2019 7:24 am

Re: symbol of Heat

Postby Connie Chen 1E » Fri Jan 24, 2020 10:13 am

I believe qp is the heat energy at a constant pressure, and when there is a constant pressure, qp=delta H.

Ariel Davydov 1C
Posts: 110
Joined: Thu Jul 11, 2019 12:16 am
Been upvoted: 1 time

Re: symbol of Heat

Postby Ariel Davydov 1C » Fri Jan 24, 2020 10:14 am

As the above comment says, delta H represents the change of energy in a reaction from its final state to its initial state, regardless of the path it took to get there. q is the heat given off by a system during a reaction, and its sign will tell us whether the reaction is exothermic (negative value) or endothermic (positive value), similarly to delta H. qp will be the same as q and delta H (an expression of heat and/or energy) but in a reaction where pressure is held constant, as denoted by the “p.”

Return to “Phase Changes & Related Calculations”

Who is online

Users browsing this forum: No registered users and 2 guests