Molar Heat Capacity

Moderators: Chem_Mod, Chem_Admin

Kendall_Islam_3A
Posts: 20
Joined: Wed Sep 21, 2016 2:57 pm

Molar Heat Capacity

Postby Kendall_Islam_3A » Sun Jan 22, 2017 1:52 pm

On page 19 in the Course Reader, molar heat capacity is defined as the "heat required to raise temp of one mole by 1 degree Celsius." However, the unit given is J/K/mol. Why are the temperature units different between the definition and the units of molar heat capacity?

Tyler_Ash_3C
Posts: 25
Joined: Wed Sep 21, 2016 2:57 pm
Been upvoted: 1 time

Re: Molar Heat Capacity

Postby Tyler_Ash_3C » Sun Jan 22, 2017 2:08 pm

Since the molar heat capacity is concerned with a temperature change, it can be expressed in terms of degrees Celsius or degrees Kelvin. Zero degrees Celsius is equal to 273.15 Kelvin, and this difference can be used to calculate degrees Celsius from Kelvin by subtracting this number, and to calculate degrees Kelvin from Celsius by adding this number. Because of this, the temperature change in degrees of either will be the same in degrees Celsius as in Kelvin. In the book on page 267 underneath table 8.2, it says that molar heat capacities commonly use Kelvins. So that is why the units involve Kelvins. The explanation of this in the course reader that uses degrees Celsius actually means the same thing if you insert Kelvins there instead.

Tina_Keshishian_2F
Posts: 19
Joined: Tue Oct 04, 2016 3:02 am

Re: Molar Heat Capacity

Postby Tina_Keshishian_2F » Sun Jan 22, 2017 9:10 pm

Is the molar heat capacity an extensive property?

Marissa Petchpradub 2F
Posts: 15
Joined: Wed Sep 21, 2016 2:56 pm

Re: Molar Heat Capacity

Postby Marissa Petchpradub 2F » Sun Jan 22, 2017 10:03 pm

I believe molar heat capacity would be considered an intensive property. It is defined as "heat required to raise the temperature of 1 mole of substance by 1 degree Celsius," therefore, since it is the heat needed for SPECIFICALLY 1 mole of substance. Molar heat capacity values do not depend on the amount of substance there is.

Helen 3C
Posts: 10
Joined: Fri Jun 17, 2016 11:28 am

Re: Molar Heat Capacity

Postby Helen 3C » Sun Jan 22, 2017 10:37 pm

Molar heat capacity and specific heat capacity are easy to confuse with heat capacity. Heat capacity is defined as the heat required to raise the temperature of an object by 1°C, and it is extensive because the heat required depends on the amount of substance. Specific heat capacity and molar heat capacity are intensive because they are the heat required to raise the temperature of 1 g of a substance by 1°C and mole of a substance by 1°C, respectively.


Return to “Heat Capacities, Calorimeters & Calorimetry Calculations”

Who is online

Users browsing this forum: No registered users and 1 guest