H=q

Moderators: Chem_Mod, Chem_Admin

Tyler Angtuaco 1G
Posts: 130
Joined: Wed Sep 11, 2019 12:16 am

H=q

Postby Tyler Angtuaco 1G » Fri Feb 07, 2020 8:48 pm

Why is it safe to assume that delta H = heat (delta H = q) for chemical reactions even if the question does not specify that pressure is constant?

Angus Wu_4G
Posts: 102
Joined: Fri Aug 02, 2019 12:15 am

Re: H=q

Postby Angus Wu_4G » Fri Feb 07, 2020 9:28 pm

I could probably answer your question better if you had a specific problem or example, but they way I see it, unless they tell you otherwise through the problem or scenario, it is safe to assume that the pressure is constant (1atm) and that temperature is 25C, since that this the temperature and pressure that most biochemical reactions occur in.

Osvaldo SanchezF -1H
Posts: 122
Joined: Wed Sep 18, 2019 12:21 am

Re: H=q

Postby Osvaldo SanchezF -1H » Fri Feb 07, 2020 10:28 pm

You cannot really assume anything. It all depends in the problem and the information that they give you. As the person above said though, most reaction occur in the situations that they mentioned unless the question says otherwise. And besides the pressure being constant, it can say that the volume is constant and it would also make deltaH= q because delta H= delta U +PV so if volume is 0 then as I stated delta H=q. Thats another possible scenario.

Orrin Zhong 4G
Posts: 51
Joined: Sat Jul 20, 2019 12:16 am

Re: H=q

Postby Orrin Zhong 4G » Fri Feb 07, 2020 10:38 pm

Yeah I would also agree that assuming a constant pressure at standard state is reasonable if a problem does not specify anything. Two other indications that would point to constant pressure would be if the problem gives you ΔH to use because that is specified at a constant pressure. Another indication would be an open system, since that would most likely indicate constant atmospheric pressure.

Maika Ngoie 1B
Posts: 97
Joined: Fri Aug 02, 2019 12:16 am

Re: H=q

Postby Maika Ngoie 1B » Sat Feb 08, 2020 12:53 pm

Just to be safe, I would not assume anything if the problem doesn't state whether or not the reaction occurs under constant pressure


Return to “Reaction Enthalpies (e.g., Using Hess’s Law, Bond Enthalpies, Standard Enthalpies of Formation)”

Who is online

Users browsing this forum: No registered users and 0 guests