## Knowing which one to use

Brandon Mo 4K
Posts: 70
Joined: Fri Sep 28, 2018 12:15 am

### Knowing which one to use

How do we tell which heat capacity to use (heat capacity, specific heat capacity, and molar heat capacity)?

Does anyone also know the variables used for them?
In my notes there are C, Cv, Cp, Csp. I am confused which one is which.

Jessica Castro 2H
Posts: 60
Joined: Fri Sep 28, 2018 12:29 am

### Re: Knowing which one to use

Heat capacity (C) is simple the heat supplied / change in temp (C = q / delta T). Specific heat capacity (Cs) is the heat capacity at a given mass (Cs = C/m), therefore q = m x Cs x delta T. Molar heat capacity (Cm) is the heat capacity at a given amount of moles (Cm = C/n), therefore q = n x Cm x delta T. Cv is the molar heat capacity at constant volume and Cp is the molar heat capacity at constant pressure.

Hedi Zappacosta 1E
Posts: 66
Joined: Fri Sep 28, 2018 12:27 am

### Re: Knowing which one to use

You just have to read the problem and consider the variables that are being kept constant. If volume is constant, use Cv and if pressure is constant, use Cp and so on. specific heat capacity and molar heat capacity are the same. It should say in the question whether youre dealing with moles or grams.

Tarika Gujral 1K
Posts: 62
Joined: Fri Sep 28, 2018 12:27 am

### Re: Knowing which one to use

Heat capacity (neither specific nor molar) is used if no mass/moles are given.

An example is using a calorimeter calibration.
q = Ccal * delta T
Then plug in Ccal to determine q for a different reaction.

Return to “Heat Capacities, Calorimeters & Calorimetry Calculations”

### Who is online

Users browsing this forum: No registered users and 1 guest