5 posts • Page 1 of 1
I am a bit confused about when we round for significant figures. In the solution manual, the values are rounded to the correct number of significant figures in each step. Are we supposed to do this or do we round to the correct number of significant figures at the very end of the calculation?
You only have to have the correct number of sigfigs for the last answer that you box. For the steps you take to get to the answer, you do not need to have correct sigfigs. However, be careful that you don't truncate numbers in each step, or else the answer you get will not be accurate, even if you have the right number of sigfigs. Just to be safe, it's better to follow sigfigs in your steps too.
So is it better to do the correct number of significant figures during each step or to use more than the correct number of significant figures to make the answer more accurate? These two methods gives different answers. The solution manual seems to truncate the values during each step and uses the correct number of sig figs. However, the answer is not as accurate. What should we do on the quiz?
Who is online
Users browsing this forum: No registered users and 1 guest